@MisterMander wrote:
Hi I’m having bags of fun with the Inky pHAT but struggling to get it working off the board. When it’s connected to the Pi directly with the header it works perfectly. I need it to run separately though, so have followed the pinout diagram exactly and connected it up with male to female jumper leads. The leads make a good connection at both ends and this approach has worked before with the unicorn phat (albeit with fewer connections). I’m absolutely certain all 8 pins are connected properly - am I missing a connection to Ground or something that’s not covered in the pinout diagram? Thanks!
Posts: 6
Participants: 2