@tam94131 wrote:
Hi all. First post here.
I have a Raspberry Pi 3 and added an LED Shim, downloaded the library and all that, ran a few of the sample python scripts and all good. Then I added an Automation HAT, downloaded the library for that and all that, created a few scripts and all good. However. Since installing the Automation HAT, the LED Shim will no longer work and returns and error. (Sorry I don’t have this handy!) Even after removing the Automation HAT (with power off of course) I get an error. In other words, the LED Shim refuses to work again. I tried re-downloading the Shim library figuring I did something wrong there. I hope I didn’t short out the Shim or something.
These two should work together? Any other issues?
Posts: 2
Participants: 2