after a failed attempt, i flashed my sd card and did a fresh install of PIOS ( with desktop) and the software for the enviro + using the * sudo ./install.shmethod . When i use thonny, the screen initializes ( with the back light turning on) but no data or graph is displayed when i run the code. When i try the screen test, the same thing happens. When i run the screen test in geany, i get this weird error code that says:
/tmp/geany_run_script_9W5WR0.sh: 7: /tmp/geany_run_script_9W5WR0.sh: ./screen: not found
(program exited with code: 127)
Press return to continue
i dont get any error code in thonny. I honestly dont know what to do. I’ve enabled spi and ic2, installed the fonts, but still nothing. I checked the solder of my gpio, and i dont see any issues that stand out. one thing to note, and im not sure if this is commonly seen, when im installing the software for the board, there is a part where it says there is a syntax error, it then momentarily stops and then continues to install the code. im not sure if that means anything.
2 posts - 1 participant