Connecting Enviro to R Pi4

Hi,

I am a beginner and received Enviro - Indoor Monitor ( I thnk it is the Enviro-mini-pHAT)
I am trying to connect it but can’t seem to have it recognized by the Pi unit

I have followed the instructions on

up to before the “example” section - rebooted but after multiple try it does not seem to get detected:

I also tried the install from the README.md with
curl -sSL https://get.pimoroni.com/enviroplus | bash

After Reboot:

Running

$Python3 weather.py

=> returns: Unable to find bme280 on 0x76, IOError

And running

$i2cdetect -y 1

=> returns only empty slots

0 1 2 3 4 5 6 7 8 9 a b c d e f
00:    -- -- -- -- -- -- -- -- -- -- -- -- --
10: – -- – -- – -- – -- – -- – -- – -- – --
20: – -- – -- – -- – -- – -- – -- – -- – --
30: – -- – -- – -- – -- – -- – -- – -- – --
40: – -- – -- – -- – -- – -- – -- – -- – --
50: – -- – -- – -- – -- – -- – -- – -- – --
60: – -- – -- – -- – -- – -- – -- – -- – --
70: – -- – -- – -- – 

This is how it’s connected to the Pi through the 40 pin.

Any help appreciated.
Is there a way to check if the Enviro unit itself is powered? faulty?

Thanks!

6 posts - 2 participants

Read full topic