Hi everyone! I’m new here and was super excited to use the Inky pHAT for a project I’ve been planning for a while now. However, I’ve had issues getting my yellow Inky to display properly. It looked fine out of the box but I’ve tried all the test scripts and they run but the pHAT won’t properly display any of them nor will it fully clear when I run the clean.py example. (See weather screen below.)
I’ve tested on two different Pi’s (Zero and 3 Model B) both through wiring the Pi with jumper wires and putting it directly onto the headers. Has anyone else had similar problems? I’m hoping it’s not something wrong with the pHAT but I’m out of ideas on what else to try.
Thanks in advance for any help!!
1 post - 1 participant