Hi All,
I’m having real problems with the hammer header and the associated jig.
I think it’s more the jig than the header… I’ve watched the instructional video and given it a go, but my header is very loose, and my pins are all bent. I tried my best to hold everything together while hammering, but the jig was all over the place and kept sliding :-(
I think the problem stems from the screws supplied with the jig. They seem far too small compared to the ones in the video, and the jig has zero stability whatsoever.
I’ve uploaded a video and some pics here (excuse the state of my garage floor).
https://1drv.ms/u/s!AtZ_z4ebqwKnxIwiqlOUnIlxys-8bA?e=tLaOk3
I’m guessing this header is beyond recovery? Any thoughts / advice?
1 post - 1 participant