i occasionally see the st7735 display get corrupted, and nothing short of a power cycle fixes it.
i’m using an automation hat mini, and unfortunately i don’t think the reset pin is supported on that board. the corruption appears as staggered images, partial colors, etc.
things i’ve tried:
-sw reset via spi commands
-reinit of the ST7735 module
-unload/reload of the spi_bcm2835 kernel module
-sudo reboot**
**yes, it persists through a reboot. nothing short of a power cycle fixes it.
Any suggestions?
Thanks.
Pach
4 posts - 2 participants