First time using input on Automation Phat

@davidn70 wrote:

Hello,

I have used the relay on the Automation Phats quite a bit. This is my first attempt at using the inputs.

I am trying to connect the output of a piece of equipment to my Automation PHat/Raspberry Pi Zero so I can tell when the output is triggered. I have the board configured, and the relay working. I am including a photo shat shows the info from the manual about the control. Any suggestions about how to go about this?

What input would the experts recommend I use? Do I need to connect some voltage in the equation? How should I wire it up?

Many thanks in advance.
David

Screen Shot 2017-11-11 at 3.37.04 PM.png710x348 18.6 KB

Posts: 1

Participants: 1

Read full topic