Hyperpixel 3.5, Buster, Pi 4 how?

@HansOtten wrote:

To check out the Pi4, current Buster (feb 2020) and Hyperpixel 3.5 I did the following:

0 Checked on a Raspberry Pi 3, current Buster, instructions followed and works fine, so hardware is OK

1 imaged a SD with current Buster (feb 2020)
2 booted on a Pi 4 1 GB
3 did the usual raspi-config things and update/upgrade
4 checked out the system, works as expected
5 curl https://get.pimoroni.com/hyperpixel | bash
6. rebooted , installed Hyperpixel

Result is rubbish, reverse image on HDMI, Hyperpixel dead

Maybe the curl https://get.pimoroni.com/hyperpixel | bash gets the old hyperpixel install and the the Pi 4? Looks like it.

So back to 0,

1 imaged a SD with current Buster (feb 2020)
2 booted on a Pi 4 1 GB
3 did the usual raspi-config things and update/upgrade
4 checked out the system, works as expected
5 downloaded the Hyperpixel Pi 4 git repository
6. rebooted , installed Hyperpixel with ./setup.h

Result is Hyperpixel noise banner, HDMI shows normal screen

So install fails with the curl or setup ,and instructions clearly wrong?

Also made a github issue of the problem.

Posts: 6

Participants: 2

Read full topic