I was on Enviro PHAT Temp & pHAT Stack trying to figure out how to plug a Pi0 with a pHAT stack, through a Ribbon and then the Enviro Plus.
I can’t get my head around it…as my setup is slightly different to the one shown in that question
I’d like to avoid the magic blue smoke :-)
Pic 1:
The white wire is on pin 1( the squared one on the PI)
Which goes to to pHat
Pic2:
Pic3:
This seems right as on pic 3 the white cable seems to map to where the third picture shows 3V
I see I could have actually got a non soldered Pi0 and get it directly on the pHat but that all new to me so for next time.
4 posts - 2 participants