@JohnH wrote:
Hi - new here - have just taken delivery of my first Raspberry pi and a BME680 module that I want to use to monitor temp remotely. Pi is running fine but when I went solder up the BME680 I tried to follow the “Getting Started” instructions and noticed that my module is slightly different to the one in the pics but more importantly, the labels for the I/O pins are reversed when compared with the ones shown on the instructions. I don’t want to get this wrong - if the labels on my board are correct the component would face the centre of the Pi and the processor heat! Help please!
Posts: 1
Participants: 1