@Culagh wrote:
I followed the instructions to set up motionEye OS on my OctoCam. I D/L’d the relevant raspberrypi Motion Eye os and wrote it to my sd card using Etcher. This where the confusion starts. After writing the img., to the SD Card it appears to create an additional SD card/partition ??, is this correct ?. I then created wpa_supplicant.conf and place it in what I thought was the Boot partitionfbut this made little difference as when I then ran the SD card, nothing happens. I’m new to this so can you say where I’m going wrong ?
Posts: 1
Participants: 1